Publicidad
Idiomas disponibles
Idiomas disponibles
TO EMPTY GRASS
CATCHER
1. Lift up on grass catcher using the
frame handle.
2.
Remove grass catcher with clippings
from under lawn mower handle.
3.
Empty clippings from bag using both
frame handle and bag handle.
NOTE:
Do not drag the bag when
emptying;
it will cause unnecessary
wear.
Grass
frame
handle
Bag
handle
BEFORE STARTING
ENGINE
ADD OIL
Your lawnmower
is shipped
without oil in
the engine. Engine holds 20 oz. of oil.
For type and grade of oil to use, see
"ENGINE"
in Maintenance
section of this
manual.
1. Be sure lawnmower
is level and area
around oil fill is clean.
2. Remove
engine oil cap
and fill to the
full line on the dipstick. Pour oil slowly.
Do not over fill.
NOTE: Allow oil to settle down into engine
for accurate reading. To read proper level,
tighten engine oil cap, then remove it to
read the dipstick.
3.
Reinstall engine oil cap and tighten.
• Check oil level before each use.
Add
oil if needed.
Fill to full line on dipstick.
• Change
the oil after every 25 hours of
operation
or each season.
You may
need to change
the oil more often
under dusty, dirty conditions.
ADD GASOLINE
• Fill fuel tank.
Use fresh, clean, regular
unleaded
gasoline with a minimum of
87 octane.
Do not mix oil with gaso-
line. Purchase
fuel in quantities that
can be used within 30 days to assure
fuel freshness.
AWARNING:
Experience indicates that
alcohol blended fuels (called gasohol or
using ethanol or methanol) can attract
moisture which leads to separation and
formation of acids during storage. Acidic
gas can damage the fuel system of an
engine while in storage. To avoid engine
problems, the fuel system should be
emptied before storage of 30 days or
longer, Drain the gas tank, start the
engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel
next season. See Storage Instructionsfor
additional information. Never use engine
or carburetor cleaner products in the fuel
tank or permanent damage may occur.
A CAUTION: Fill to bottom of gas tank
filler neck. Do not overfill. Wipe off any
spilled oil or fuel, Do not store, spill or
use gasoline near an open flame.
Gasoline
filler cap
8
Engine
oil cap
TO START
ENGINE
NOTE:
Due to protective coatings on the
engine, a small amount of smoke may be
present during the initial use of the
product and should be considered
normal.
1. To start a cold engine, push primer
three (3) times before trying to start.
Use a firm push. This step is not
usually
necessary
when starting
an
engine which has already
run for a
few minutes.
2.
Hold operator
presence
control
bar
down to the handle.
3. Turn electric
start key clockwise
to
crank
engine.
IMPORTANT:
Do not crank engine more
than five continous
seconds between
each time you try to start. Wait 5 to 10
seconds
between
each attempt.
1. To start engine
using the auxiliary
starter
handle,
follow the steps above.
Exchange
the use of the start key for
starter
handle.
Pull starter
handle
quickly.
Do not allow starter
rope to
snap back.
Publicidad
