Forest-Master FMX4 Manual Del Usuario página 11

Fasten the rear cage panel to the left hand rear flange of the
tray, using 2 M6x16 cap head bolts, 4 M6 thin washers (one
under the bolt head and one under the nut) and 2 M6 nyloc
nuts. Do nut fully tighten any cage bolts until assembly is
complete.
Do not add a nut
and bolt
stage.
FMX4 (Models D & TW)
at this
Attach the longer of the two plain cage panels
to the left side of the tray and the rear cage
panel. The bottom rear corner has two closely
spaced holes, the top rear corner has a single
hole approximately 10mm from the rear edge.
Do not fasten the top rear corner at this stage.
Use 5 M6x12 button head bolts, 10 M6 flat
washers (1 under each bolt head and 1 under
each nut) and 5 M6 nyloc nuts. Leave all nuts
and bolts finger tight until the last step, this
makes it easier to adjust the cage.
M6X12 SOCKET HEAD BOLT
M6 FLAT WASHER
M6 FLAT WASHER
M6 NYLOC NUT
11