Stihl HSA 100.1 Manual De Instrucciones página 30

English
► Release the control bar.
The cutting blades stop running after about 1
second.
► If the cutting blades continue to run after 1
second: Remove the battery and contact your
STIHL authorized dealer.
The hedge trimmer is defective.
10.2 Testing the Battery
► Press button on battery.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use
the battery and contact your STIHL servicing
dealer.
There is a malfunction in the battery.
11 Operating the Hedge Trim‐
mer
11.1 Holding and Controlling the
Hedge Trimmer
► Hold the hedge trimmer with one hand on the
control handle – wrap your thumb around the
control handle.
► Hold the hedge trimmer with the other hand on
the loop handle – wrap your thumb around the
loop handle.
11.2 Turning the Control Handle
The control handle can be set to three (3) posi‐
tions depending on the application.
1
► Pull out and hold the locking slide (1).
► Rotate the control handle (2) clockwise or
counterclockwise.
► Release the locking slide (1).
30
► Rotate the control handle (2) clockwise or
counterclockwise until the control handle (2)
snaps into place.
11.3
► Use pruning shears or a chainsaw to cut out
thick branches first.
► Swing the hedge trimmer from the bottom
upwards in an arc while making the cut.
► Lower the nose of the hedge trimmer without
cutting.
► Walk forward slowly in a controlled manner.
► Swing the hedge trimmer from the bottom
upwards in an arc while making the cut.
► Cut the other side of the hedge in the same
way.
► Hold the cutting blades at an angle of 0° to 10°
to the top of the hedge.
► Swing the hedge trimmer horizontally and in
an arc while making the cut.
► If cutting performance deteriorates: Sharpen
the cutting blades.
For optimum performance, observe the recom‐
mended temperature ranges,
12 After Finishing Work
12.1
► Switch off the hedge trimmer and remove the
battery.
► If the hedge trimmer is wet: Allow the hedge
trimmer to dry.
► If the battery is moist or wet: Allow the battery
to dry,
► Clean the hedge trimmer.
► Clean the cutting blades.
► Fit the blade scabbard so that it completely
covers the cutting blades.
► Clean the battery.
2
11 Operating the Hedge Trimmer
Cutting
0-10°
After Finishing Work
19.5.
19.5.
0458-020-9802-A