Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING! Never operate the tool without the guard properly in place. Use of
the unit without having installed the guard will cause the motor to overheat,
and void the warranty.
7.2
Auxiliary handle assembly (see fig 2)
Note: This may already be pre-fitted to the trimmer. However the following instructions give full
assembly details
1. Push auxiliary handle knobs on both sides .
2. While pushing the knobs, slide the handle on to the handle bracket assembly located on
trimmer's shaft. (once the auxiliary handle is placed in position, the knobs can be released).
To adjust : Push on the auxiliary handle locking knobs (see fig 2).
The auxiliary handle's bracket can be moved up or down on the shaft and the auxiliary handle
itself can be moved forward or backward into 5 different locked positions (fig 3) while knob is
pushed.
Lock by releasing the knobs, to fix handle in the desired height.
8
OPERATION
8.1
Starting
▪
To switch on the trimmer first press the On/Off trigger (1). To switch off simply release the
On/Off switch trigger(1)
▪
If you find that the nylon line is too short, let the trimmer run for a few seconds touching
the working area to allow the trimmer to cut the line after it lengthens.
▪
Do not overload the trimmer, cut in small sections which will greatly improve efficiency by
keeping the trimmer running at high speed,
▪
Use the edge of the guard as a guide when cutting near fences and walls, etc.
8.2
Adjust the telescopic length
To adjust the telescopic shaft, simply unscrew the height adjustment locking collar and slide
the shaft to the desired height (see fig 4)
Screw to fix the shaft at this desired length (see fig 5)
9
USING THE TRIMMER AS AN EDGER (FIG. 6)
Before making this change, make sure that the device is switched off and
completely separated from the power mains.
For edging driveways and paths, transform the trimmer from trimmer mode to edging mode
as follows:
▪
Lift up the rotation locking collar (4) and turn the top of the shaft 180° counter-clockwise
(The head will only move in one direction). Release the rotation locking collar back to
lock the shaft in place.
▪
Now the trimmer can be used as an edge trimmer.
Warning: To prevent accidental starts which may cause serious personal
injury, always disconnect the power cord before attempting to rotate the
shaft.
In order to reduce strain on the cable inlet, form a loop and locate the cable
around the strain relief hook.
Copyright © 2022 VARO
POWXG30033
P a g e
| 6
EN
www.varo.com
Publicidad
