10
INTELLIGENT LINE FEED
When initially switching on the trimmer, a small length of line is fed out.
A 'clattering' noise will be heard when the lines hit the line cutter. DO NOT BE ALARMED this
is quite normal. After about 5 seconds the line will be cut to the correct length and the noise
will reduce as the motor receives full speed.
If the noise of the line being cut can't be heard, more line will be fed out.
This trimmer has an intelligent line feed, so the spool will automatically feed more line when
needed, and when the line is subjected to some resistance.
No need to stop machine, as this system will act itself.
Make sure that line is fed out before operation. Make sure motor is up to full speed before
trimming.
Use only 1.60mm diameter cutting line. Other sizes of line will not feed properly and will result
in improper cutting head function or can cause serious injury. Do not use other material such
as wire, string, rope, etc. Wire can break off during cutting and become a dangerous missile
that can cause serious injury.
11
TROUBLE SHOOTING
PROBLEM
Line will not
advance
Cutting head is
hard to turn
Grass continually
wraps around
the shaft and
trimmer head
assembly
Line trimmer
stops and will not
start again
12
TECHNICAL DATA
Rated voltage
Rated frequency
Rated Power
No load speed
Cutting width
Line size
Cutting system
Weight
Copyright © 2022 VARO
POSSIBLE CAUSE
▪
Line is welded to itself
▪
Not enough line on the spool
▪
Line has worn too short
▪
Line is tangled on the spool
▪
Grass wrapped or built up
around head
▪
Cutting tall grass at ground
level
▪
Unit failed
▪
Plug is damaged
P a g e
POWXG30033
SOLUTION
▪
Lubricate with a silicone
spray
▪
Replace the spool
▪
Remove the spool and feed
line out
▪
Remove line from spool and
rewind
▪
Clean the effected parts of
the machine
▪
Cut tall grass from the top
down
▪
Contact dealer to check
damage
▪
Check the plug
230V
50Hz
500
9000 min
320 mm
Φ1.6mm
2 lines/Intelligent system
2.5kg
| 7
-1
www.varo.com
EN