Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1.
Shut off the water at the supply valves under the sink or at the main water
supply. Disconnect the supply lines. Remove the existing faucet from the
sink.
Clean and dry the surface area where the new faucet will be mounted.
2.
To install with the optional deckplate for a 3-hole sink, skip to Step 3.
Carefully insert the integrated water supply lines (2.1) and shank (2.2) on the
faucet body (A) through the mounting hole in the sink (2.3). Skip to Step 4.
3.
Optional deckplate installation:
Apply a thin bead of silicone to the underside of the gasket (C). Place the
gasket (C) and deckplate (B) over the mounting holes in the sink, aligning the
center hole in the gasket (C) and deckplate (B) with the center mounting hole
in the sink (3.1).
Carefully insert the integrated water supply lines (3.2) and shank (3.3) on the
faucet body (A) through the hole in the deckplate (B), gasket (C), and the
mounting hole in the sink (3.1) until the faucet sits on top of the deckplate
(B).
4.
From underneath the sink, secure the faucet body (A) to the sink using the
rubber gasket (CC), washer (BB), and quick-install mounting nut (AA). Push
the quick-install mounting nut (AA) upwards over the faucet shank (4.1) until
it is pressed firmly against the underside of the sink and turn to tighten. Do
not overtighten.
NOTE: It is helpful to have a second person hold the faucet in place while
tightening the quick-install mounting nut (AA).
Hardware Used
Quick-install
AA
mounting nut
BB
Washer
CC
Rubber gasket
x 1
1
x
1
x
4
1
2
A
2.2
2.1
2.3
3
A
3.3
3.2
C
3.1
4
A
4.1
CC
BB
AA
B
Publicidad
