Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 11 Tuesday, April 23, 2024 10:09 AM
Installing and Testing the
Oven
Unpacking
WARNING
• This model should be installed without removing
oven doors.
• Keep packing materials out of the reach of
children. Packaging material can be dangerous
for children. There is a risk of suffocation.
• You should use two or more people to move and
install the appliance. (Excessive Weight Hazard)
Failure to do so can result in back or other injury.
• Do not use the door handles to push or pull the
appliance during installation or when moving
the appliance out for cleaning or service. Doing
so can result in serious damage to the door of
the appliance.
• To reduce the risk of burns, do not move this
appliance while it is hot.
NOTE
• To remove any remaining tape or glue, rub the
area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing a
small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm
water and dry.
• Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove
Category
Single wall oven
Double wall oven
Category
Single wall oven
Double wall oven
tape or glue. These products can damage the
surface of your appliance.
Unpacking Materials
Remove any packing material from the oven
before installing the oven.
1
Remove all tape from around the oven.
2
Open the oven door and remove the
packaging materials and oven racks inside the
oven.
Electrical Requirements
Ensure that dedicated circuit protection is
prepared as recommended and that the appliance
is grounded properly.
• This wall oven must be electrically grounded in
accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA
No.70- latest edition in United States, or with CSA
Standard C22.1-1982 and C22.2 No.01982 (or
latest edition), Canadian Electrical Code, Part1,
and all local codes and ordinances.
• This wall oven must be supplied with the proper
voltage and frequency, and connected to an
individual, properly grounded branch circuit,
protected by a circuit breaker or fuse. For
information on the circuit breaker or fuse
required by this model, see the rating plate to
find the wattage consumption and refer to the
table below to get the circuit breaker or fuse
amperage.
Appliance rating Watts 240 V
Power consumption
6100 W
(SKSSV3011MT)
10700 W
(SKSDV3012MT)
Appliance rating Watts 208 V
Power consumption
4600 W
(SKSSV3011MT)
8100 W
(SKSDV3012MT)
INSTALLATION
11
Protection circuit
recommended
30 A
50 A
Protection circuit
recommended
30 A
40 A
Publicidad
