Descargar Imprimir esta página

Zizito JUNONA II Manual Del Usuario página 19

Asiento elevador

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 32
INSTALLING THE JUNONA IN THE CAR WITH A 3-POINT CAR
SAFETY BELT (1-2)
Follow the instructions as shown on the instruction label placed on the side of
the backrest. We recommend that you place the Junona on the rear seat in the
car, facing forward.
The Junona consists of three parts: an adjustable headrest, a backrest and a
seat booster.
1. Your child should only use the complete Junona when he/she weighs at
least 15 kg. Remove the headrest of the passenger seat being used if it
causes an obstruction for proper installation of the Junona.
2. When you child weighs about 22 kg, it should only use the seat boost-
er of this Zizito. Do not forget to replace the headrest of the passenger
seat, when you use it with only a seat booster. The belt routing areas are
marked in red. You will see a red mark under the armrests of the booster
and a red mark on the same height as both car belt hooks.
3. This product belongs to the universal category of child restraint systems,
approved for weight groups II and III for children weighing from 15 to 36 kg
4. All straps securing the restraint system to the vehicle must be tensioned,
all straps holding the child must be adjusted to the child's body and the
straps must not be twisted.
5. It is very important to ensure such use of the hip belt low down so that the
pelvis is firmly gripped by it.
6. No changes should be made to the seat, as this may partially or complete-
ly affect its safety.
PLACING YOUR CHILD IN THE JUNONA (A-J ILLUSTRATIONS;
SEE INSIDE COVER-FLAP)
Position the Junona with its backrest firmly against the backrest of the carseat.
Make sure that the product is not placed on the safety belt buckle (B). Put the
seat belt around the child. Thread the lap belt under both armrests (conform
the red markings on the seat booster). Insert the buckle tongue in the belt
buckle (C1) and pull the lap belt tight (C2).
Thread the shoulder belt under the armrests back again and then over the
shoulder through the (red marked) belt hook on the headrest (D1). For maxi-
mum safety: again pull the shoulder belt tight in upwards direction (D2).Make
sure that the belt is not twisted.
19

Publicidad

loading

Este manual también es adecuado para:

Yy01