Zizito JUNONA II Manual Del Usuario página 20

EN CHECK THE CORRECT HEADREST HEIGHT (E)
To ensure the correct headrest height is obtained, the belt hook should be
located slightly above the shoulders of your child (this distance should be
between 0.5 and 2.5 cm). You can adjust the height of the headrest by holding
the backrest with one hand, and pull the headrest upwards (or push it down-
wards) with your other hand at the top.When the next position is reached, you
here a click.
REMOVING THE BACKREST FROM THE SEAT BOOSTER (G)
Push the backrest (together with the headrest) downwards until you feel some
resistance. Gently push the backrest until it lies flat(G1). Remove the backrest
by lifting the hooks out of the openings in the seat booster(G2).
INSTALLATION OF BOOSTER(H)
Put the seat belt around the child. Thread the lap belt under both armrests
(conform the red markings on the seat booster). Insert the buckle tongue in the
belt buckle (H1) and pull the lap belt tight (H2). Thread the shoulder belt under
the armrests back again and then over the children shouder. For maximum
safety: again pull the shoulder belt tight in upwards direction (H2). Make sure
that the belt is not twisted.
NOTE!
• The tighter the belts are around the child, the better the protection. When
your child is complaining about too much tension, check if the shoulder
belts should be adjusted to a higher position. The space between the belt
slots and the shoulders of your child should be between 0.5 and 2.5 cm.
• The belts should never be twisted.
• If you are unable to click the tongue section in the buckle, unblock the
buckle and try agian. EN
• If you are not able to fasten the harmess belt properly or pull it tight, con-
tact your supplier immediately. Under no circunstances use the product!
REMOVING THE COVER (J)
Headrest: pull the cover over the top of the headrest. Make sure that the foam
parts remain in position.
Backrest: loosen the Velcro fastener at the backside of the cover and pull it
over both lumbar supports.
20