Explanation of symbols
Danger of electrical shock.
Important warning regarding operation of device
Important information regarding operation of device
Important safety information
All warranty claims are invalid in the event of damage. caused by operating the system in
non-compliance with this user guide. ABUS USA, LLC cannot be held liable for resulting
damages.
In the event of material or personal damage caused by improper operation or non-
compliance with the safety information, ABUS USA, LLC cannot be held liable. All warranty
claims are voided in such cases.
This device has been manufactured in accordance with international safety standards.
Please read the following safety instructions carefully.
Safety information
1.
Power supply
110 V AC voltage, 60 Hz (using a power supply unit for 5 V DC/12 V DC)
Only operate this device using a power source which supplies the grid voltage specified on the type
plate. If you are unsure which voltage is supplied at the installation location, contact your power supply
company. Disconnect the device from the power supply before carrying out maintenance or installation
work. The power supplies are only for indoor usage.
2.
Overloading
Avoid overloading electrical sockets, extension cables and adapters, as this can result in fires or electric
shocks.
3.
Liquids
Make sure that no liquids of any type are able to enter the device.
4.
Cleaning
Only use a damp cloth to clean the device. Do not use corrosive cleaning materials.
Disconnect the device from the power supply while doing so.
5.
Accessories
Only connect devices that are suitable for the intended purpose. Otherwise, hazardous situations or
damage to the device can occur.
6.
Installation position
This device can be used inside as well as outside.
The product will be damaged even it falls from a low height.
During the installation of the camera please take care that the camera image sensor does not
point directly into the sunlight. Please follow the installation instructions in the corresponding
chapter of this user manual.
Do not place the device near a radiator or heat register.
Only operate the device at temperature range of 14 °F to 122 °F l. Outside the predetermined
temperature range operation is possible, but cannot be guaranteed.
5
English