cecotec SPRINT Manual De Instrucciones página 88

ENGLISH
Error code
E06
E07
E08
E09
E10
E11
Parameter setting menu
Adjust brightness (P01). Fig. 17
When you have started the bike, press the
Briefly press the
to go to the settings for the next parameter.
Unit of measurement (P02). Fig. 18
Briefly press the
and speed). Then, briefly press the
Set the voltage level (P03). Fig. 19
Briefly press the
V, 48 V, 60 V. Then, briefly press the
Set the latency time (P04). Fig. 20
Briefly press the
latency time. Then, briefly press the
Set the wheel diameter (P06). Fig. 21
Briefly press the
is: 5.0-50.0 inches. Then, briefly press the
Set zero start or other non-zero starts (P09). Fig. 22
Briefly press the
corresponds to zero start and setting 1 corresponds to other non-zero starts. Then, briefly
press the button to go to the settings for the next parameter.
88
SPRINT | SPRINT SILVER
Description
Battery is running low
Electronic failure
Handlebar failure
Controller failure
Data reception failure
Data sending failure
or button and adjust the brightness. Then, briefly press the
or button to set the unit of measurement (used to synchronise mileage
button to go to the settings for the next parameter.
or button to adjust the voltage level, you can choose between: 24 V, 36
button to go to the settings for the next parameter.
or button to set the latency time, 0-60 minutes. Setting 0 means no
or button to adjust the wheel diameter in inches. The adjustment range
or button to set zero start or other non-zero starts. Setting 0
and buttons simultaneously to enter P01.
button to go to the settings for the next parameter.
button to go to the settings for the next parameter.
button