Publicidad
Idiomas disponibles
Idiomas disponibles
REVERSE OPERATION SYSTEM (ROS)
Your tractor is equipped with a Reverse
Operation System (ROS). Any attempt by
the operator to travel in the reverse direction
with the attachment clutchengaged willshut
off the engine unless ignitionkey is placed
in the ROS "ON" position.
_WARNING:
Backing up with the at-
tachment clutch engaged while mowing is
stronglydiscouraged.Turningthe ROS "ON",
to allow reverse operation with the attach-
ment clutch engaged, should only be done
when the operator decides itis necessary to
reposition the machine with the attachment
engaged. Do not mow in reverse unless
absolutely necessary.
USING
THE REVERSE
OPERATION
SYSTEM
-
Only use if you are certain no children or other
bystanders will enter the mowing area.
1. Move
motion control lever to neutral
position.
2. With engine running,
turn ignition key
counterclockwise
to ROS
"ON" posi-
tion.
3. Look down and behind before and while
backing.
4. Slowly
move
motion
control
lever
to
reverse
(R) position to start movement.
5. When useofthe
ROS is nolongerneeded,
turn the ignition
key clockwise
to engine
"ON" position.
ROS "ON" Position
Engine "ON" Position
(Normal Operating)
TO OPERATE
ON HILLS
_WARNING:
Do not drive up or down
hills with slopes greater than 15 ° and do not
drive across any slope. Use the slope guide
provided at the back of this manual.
• Choose the slowest speed before starting
up or down hills.
• Avoid stopping or changing
speed
on
hills.
• If stopping is absolutely necessary, push
clutch/brake pedal quicklyto brake position
and engage parking brake.
• Move motion control leverto neutral posi-
tion.
IMPORTANT: The motion control leverdoes
not returnto neutral position when the clutch/
brake pedal is depressed.
• To restart movement, slowly release park-
ing brake and clutch/brake pedal.
• Slowly move motioncontrol lever to slow-
est setting.
• Make all turns slowly.
TO TRANSPORT
When pushing or towing your tractor, be
sure to disengage transmission by placing
freewheel control in freewheeling
position.
Freewheel control is located at the rear
drawbar of tractor.
1. Raise attachment lift lever to its highest
position.
2. Pullfreewheel controloutand intothe slot
and release so itisheld inthe disengaged
position.
• Do not push or tow tractor at more than
two (2) MPR.
• Tore-engagetransmission, reverse above
procedure.
TRANSMISSION
ENGAGED
TRANSMISSION
DISENGAGED
NOTE: To protect hood from damage when
transportingyour tractorona truckor a trailer,
be sure hoodis closedand secured totractor.
Use an appropriate means of tying hood to
tractor (rope, cord, etc.).
TOWING CARTS AND OTHER ATTACH-
MENTS
Tow only the attachments that are recom-
mended by and comply with specifications
of the manufacturer of your tractor. Use
common sense when towing. Too heavy of
a load, while on a slope, is dangerous. Tires
can lose traction with the ground and cause
you to lose control of your tractor.
3
/
Publicidad
