Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:TO AVOIDSERIOUSINJURY,BEFOREPERFORMING ANY
SERVICEORADJUSTMENTS:
.
2.
3.
4.
5.
6.
Depress
clutch/brake
pedal fully and set parking
brake.
Place motion control lever in neutral
position.
Place attachment
clutch
in "DISENGAGED"
position.
Turn ignition
key to "STOP"
and remove
key.
Make sure the blades and all moving
parts have completely
stopped.
Disconnect
spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TO REMOVE
MOWER
1. Place
attachment
clutch
in "DISEN-
GAGED"
position.
2. Lower attachment lift lever to its lowest
position.
3.
Roll belt off engine pulley (M) and belt
keepers (G).
4.
Remove
retainer spring (K), slide collar
(L) off and push housing
guide (P) out
of bracket.
5.
Remove
clutch
cable
spring
(Q) from
idler arm (R).
6.
Disconnect
front link (E) from mower -
remove
retainer spring and washer.
7.
Go to either side of mower and discon-
nect mower
suspension
arm (A) from
•chassis pin (B) and rear lift link (C) from
rear mower bracket (D) - remove retainer
springs and washers.
,_ CAUTION:
After rear lift links are discon-
nected, the attachment lift lever willbe spring
loaded. Have a tight grip on lift lever when
changing position of the lever.
8.
Slide mower out from under right side of
tractor.
IMPORTANT:
If an attachment
other than
the mower is to be mounted on the tractor,
remove
the front link (E) and rear lift !iks
(C) from tractor and hook the clutch spring
(Q) into the cable
guide on front edge of
lower dash.
TO INSTALL
MOWER
Be sure tractor is on level surface and engage
parking brake.
1. Lower attachment lift lever to its lowest
position.
CAUTION:
Lift lever is spring loaded.
Have a tight grip on lift lever, lower it slowly
and engage in lowest position.
NOTE:
Be sure mower side suspension
arms (A) are pointing forward before sliding
mower under tractor.
2. Slide mower under tractor until it is cen-
tered under tractor.
21
03042tex
Publicidad
