Publicidad
Idiomas disponibles
Idiomas disponibles
Keys
(2) Keys
Slope Sheet
Your new tractor has been assembled at the factory with the exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools as
necessary to insure proper tightness.
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench
set will make assembly
easier.
Standard
wrench sizes you need
are listed below.
(1) 3/4" wrench
(1) Pliers
(1) 1/2" wrench
(1) Utility knife
(1) Tire pressure
gauge
When right or left hand is mentioned in this
manual, itmeanswhenyou areintheoperating
position (seated behind the steering wheel).
CHECK BA'I-FERY
1. Lift seat pan to raised position.
NOTE: If this battery is put intoservice after
month and year indicated on label (label
located between terminals) charge battery
for minimum of one hourat 6-10 amps. (See
"BATTERY" in Maintenance section of this
manual for charging instructions).
Seat
Label
TO
REMOVE
TRACTOR
FROM
CARTON
UNPACK
CARTON
1. Remove all accessible
loose parts and
parts boxes from carton.
2. Cut along dashed lines on all four panels
of carton. Remove
end panels and lay
side panels flat.
3. Check for any additional loose parts or
cartons and remove.
Terminal
TO ADJUST SEAT
Grasp adjustment handle (A) and pull up,
slide seat to desired position and release
adjustment handle.
7
Publicidad
