Starting up the device
Set the trigger into the desired position.
● Position "1 ON": The suction / blow-
ing function is activated.
● Position "0 OFF": The device is
switched off.
Operation
Notes on operation
ATTENTION
Dirt/dust in the area of the battery
holder
If dirt/dust accumulates in the area of
the battery holder, it may not be possi-
ble to properly insert or remove the
battery pack.
Keep the battery holder area clean.
Note
Pay attention to the latest part num-
bers when purchasing and installing fil-
ter bags and cartridge filters.
Information on accessories and spare
parts can be found at www.kaerch-
er.com.
Dry vacuuming
ATTENTION
Sucking cold ashes
Device damage
10
Only vacuum cold ash with an ash pre-
separator.
ATTENTION
Defective or wet foam filter / car-
tridge filter
Device damage
Before intial startup, check the foam fil-
ter / cartridge filter for damage and re-
place it if necessary. Vacuum only with
a dry foam filter / cartridge filter.
Depending on the configuration, a
foam filter or a cartridge filter is includ-
ed.
For devices with foam filter: Always
use filter bags in addition to the foam
filter when dry vacuuming.
For units with cartridge filter: Always
use filter bags in addition to the car-
tridge filter when vacuuming fine
dust.
Note
Regularly replace the filter bag when
full as a filter bag that is too full could
be damaged. The filling level of the fil-
ter bag depends on the dirt being vac-
uumed. The filter bag should be
replaced more often in the case of fine
dust, sand, etc.
Wet vacuuming
ATTENTION
Wet vacuuming with a filter bag
Device damage
Do not use a filter bag when vacuum-
ing wet debris.
ATTENTION
Operation with full container
When the container is full, the float
switch closes the suction opening and
the device runs at a higher speed.
Switch off the device immediately and
empty the container.
English