Publicidad
Idiomas disponibles
Idiomas disponibles
To check the specified time and source
Press the TIMER button while pressing the SHIFT button on the
remote control. The selected source name, the timer-on time
and the duration for the timer-activated period are displayed for
4 seconds.
To change the timer setting
Set the timer again from the beginning.
To cancel timer standby mode temporarily
Press the TIMER button repeatedly while pressing the SHIFT
button on the remote control so that "TIMER OFF is displayed
on the display.
To restore the timer standby mode, select "TIMER @ REC" or
"TIMER @ PLAY" instead of "TIMER OFF?
Using the
system while the timer is set
You can use the system normally after setting the timer.
Before turning off the power, prepare the source and the recording
source, and adjust the volume and tone.
0 Timer play and timer recording will not begin unless the power
is turned off.
IJConnected equipment cannot be turned on and off by the built-
in timer of this system. Use an external timer.
SETTING THE SLEEP TIMER
SLEEP
The system can be turned off automatically at a specified time.
Use the remote control.
1 Press the SLEEP button while pressing the SHIFT
button on the remote control.
2 Within 4 seconds,
press the +4
or PP
button
to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time SLEEP
To check the time remaining
until the power is turned
off
Press the SLEEP button once while pressing the SHIFT button
on the remote control. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press the SLEEP button twice while pressing the SHIFT button
on the remote control so that "SLEEP OFF" is displayed.
ENGLISH
19
Publicidad
