Descargar Imprimir esta página

Beta 019660091 Manual De Instrucciones página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 26
INSTRUCTIONS FOR USE
ISTRUZIONI PER L'USO
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING TOOL
Failure to observe trhe following warnings may result in physical injury and/or disease
WEAR PROTECTIVE MASK AGAINST PHYSICAL AGENTS ACCORDING TO THE
VALUES FOUND IN THE ENVIRONMENTAL/INDUSTRIAL HYGIENE SURVEY.
ALWAYS WEAR EYE PROTECTION WHILE OPERATING TOOL OR PERFORMING
MAINTENANCE JOBS.
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE
OPERATING TOOL.
ALWAYS WEAR SAFETY SHOES.
Additional personal protective equipment to wear according to the values found in the environmental hygiene/risk
analysis survey if the values exceed the limits under current regulations.
WEAR ANTIVIBRATION GLOVES FOLLOWING A SPECIALLY CONDUCTED
SURVEY OF LEVEL OF DAILY EXPOSURE OF HAND-ARM SYSTEM TO
VIBRATION.
WEAR PROTECTIVE HELMET.
ALWAYS WEAR HEARING PROTECTION WHILE OPERATING TOOL.
IMPACT DRILL USE AND CARE
- Use clamping devices or a vice to secure and support the workpiece. Holding the workpiece by hand or against your body will
not allow for safe operation of the electric tool.
- Do not overload the electric tool. Use the tool intended for your work only.
- Always check that the tool is free from defects. Do not use an electric tool that has a defective on/off switch. An electric tool that
can no longer be stopped or started is dangerous and must be repaired.
- Disconnect the power supply before making any adjustments, changing accessories, or placing the electric tool aside. This safety
measure prevents accidental starting of the electric tool.
- Store idle electric tools out of the reach of children. Do not allow persons unfamiliar with these instructions to operate the electric
tool.
- Maintain the electric tool with care. Check for misalignment or binding or moving parts, breakage or damage of parts and any
other condition that may affect the operation of the electric tool. Have any damaged parts repaired before using the electric tool.
- Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are
easier to control.
EN
I
9

Publicidad

loading

Este manual también es adecuado para:

1966/910w