Black Diamond RECON X Manual De Instrucciones página 11

4.3 SWITCHING ON | SELF-CHECK | SEND MODE
NOTICE Despite a comprehensive self-check, a beacon mode check (SEND check and SEARCH check) is
obligatory prior to every tour! Every member of the group must verify that both the SEND and
SEARCH modes are functioning correctly.
Switching on: Move the slider lock (1C) to the left and the slider (1B) upwards into the position SEARCH. Then
release the slider lock (1C) and move the slider (1B) downwards, until it locks in the position SEND.
DANGER Risk of incorrect switch position
Always physically verify the Slider is securely locked into position: 'SEND'. The Slider (1B)
should not move unless the Slider Lock (1C) is dis-engaged.
The display shows firmware version, battery capacity, self-check progress (4A), self-check result (4B), group check
countdown (4C) and finally the SEND display with the active transmitting antenna (4D).
The device is now in SEND mode, the transmit control LED (1G) is blinking.
NOTICE A minimum distance of 5 m from other devices and all electronic, magnetic and metallic sources
of interference should be kept during the self-check.
If the self-check is successful, "OK" is indicated on the display (4B). In the event of a device warning, an alert signal
sounds and the display indicates "E" in combination with a number (4E). For error codes, see chapter 6.1.
4A
Firmware version
Battery capacity/type
(AL=Alkaline,
LI=Lithium)
BLACK DIAMOND RECON X MANUAL
4B 4C
Self-check OK Group check
countdown
4D 4E
SEND display Self-check error
10