Aiwa AD-6300 Instrucciones De Manejo página 7

CAUTIONS
Please observe the following cautions in order to obtain
maximum performance from this tape deck.
1) Soiled heads can noticeably impair sound quality. Always
keep the heads clean.
2) When storing recorded cassettes, do not place them near .
magnets, motors, TV sets, or other magnetic field generating
sources. These can cause noise or partial erasure of the tape.
Avoid locating this set (or cassette tapes) in direct sunlight,
near radiators, heaters, on top of amplifiers or in the vicinity
of other sources of heat.
4) Do not use or store this tape deck (and tapes) in extremely
cold surroundings. Full performance and operation can be
impaired. Rated operating ambient temperature range of this
set is 0°C ~ +35°C (about 32 > 100°F).
5) If tape is slack, it can jam in the pinch roller and be damaged.
As shown below, use a pencil or similar tool to remove slack
before using the cassette.
3
SPECIFICATIONS
Type
Track Format
Circuitry
Power Supply
Power Consumption
Frequency Response
SN Ratio
Wow & Flutter
Tape Speed
Rewind Time
Fast Forward Time
Recording System
Erase System
Motor
Head
Inputs
Outputs
Dimensions
Weight
Accessories
Stereo cassette tape deck w/built-in
Dolby NR System
4 tracks 2 channels
2 IC, 28 transistors, 15 diodes, 3 LED
AC 110-120 V/220~240 V, switchable
50 Hz/60 Hz
10 М
according to DIN 45 500 Blatt 8
LH tape: 30 — 12,500 Hz
CrO2: 30 ~ 16,000 Hz
Fe-Cr tape: 30 ~ 16,000 Hz
LH tape: 30 ~ 14,000 Hz
СгО» tape: 30 ~ 16,000 Hz
Fe-Cr tape: 30 ~ 16,000 Hz
according to DIN
58 dB (Fe-Cr tape, DOLBY NR ON)
58 dB (CrO2 tape, DOLBY NR ON)
60 dB (Fe-Cr tape, DOLBY NR ON)
60 dB (CrO2 tape, DOLBY NR ON)
according to DIN 45 500 Blatt 8
0.18%
0.09% (WRMS)
4.8 cm/sec. (1—7/8 ips)
85 sec. (C-60)
85 sec. (C-60)
AC bias (frequency 85 kHz)
AC erase
DC servo motor
Ultra-hard quality permalloy head
MIC max. sensitivity 0.3 mV
(200 ohms~10 К ohms usable)
LINE IN max. sensitivity 50 mV
(more than 50 k ohms)
DIN max. sensitivity 0.1 mV/k ohms
(3 k ohms)
LINE OUT standard level 0.775 V (0 VU)
Optimum load impedance more than
50 k ohms
DIN standard level 0.775 V (0 VU)
Headphones 8 ohms
420(W) x 162(H) x 300(D) mm
6.7 kg
Connection cord 1
Head cleaning stick
Tape cassette 1
e Specifications and external appearance are subject to change
without notice due to product improvement.
e Dolby Noise Reduction System is licensed from Dolby
Laboratories Incorporated.
е The name"Dolby"and the "Double D" symbol are trademarks
of Dolby Laboratories Incorporated.