Makita LS1440 Manual De Instrucciones página 7

ENGLISH (Original instructions)
SPECIFICATIONS
Blade diameter
Hole diameter
Max. kerf thickness of the saw blade
Max. Miter angle
No load speed
Dimensions (L x W x H)
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Max. Cutting capacities (H x W)
122 mm x 152 mm
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
DOUBLE INSULATION
Wear safety glasses.
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
Do not place hand or fingers close to the
blade.
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
Model
Net weight
Safety class
0°
For other than European countries
For European countries
596 mm x 550 mm x 630 mm
Miter angle
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
7 ENGLISH
LS1440
355 mm
25 mm or 25.4 mm (Country specific)
25 mm
3.4 mm
Left 45° , Right 45°
-1
3,900 min
33.1 kg
/II
45° (left and right)
122 mm x 115 mm
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human
health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive
on waste electrical and electronic equip-
ment and its adaptation to national law,
used electrical and electronic equipment
should be collected separately and
delivered to a separate collection point
for municipal waste, operating in accor-
dance with the environmental protection
regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.