Publicidad
Idiomas disponibles
Idiomas disponibles
REFRIGERATORFEATURES
DOOR FEATURES
Important information to know about glass shelves
an_
covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature
changes or impact, such as bumping.
Tempered
glass is designed to shatter into many small,
pebble-size
pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
' S se yes
To Remove
or Adjust
Upper Shelves:
1. Remove the shelf by lifting it up and out of the shelf brackets.
2. Remove the two shelf brackets and reposition them in the
desired location.
3. Replace the shelf by inserting it into the shelf brackets.
NOTE: Be sure the shelf is level.
\
To Remove
and Replace
Lower
Shelf:
1. The very bottom glass shelf slides straight out.
2. Replace the shelf by aligning the edges with the guides and
pushing it in toward the back of the refrigerator.
\
D@@_ _ B __S;v_
_':"
Your refrigerator has two door bin locations for maximum storage
capacity.
To Remove
and Replace
the Door Bins:
1. Remove the door bin by tilting it forward and pulling it out.
2. Replace the bin by placing the rear of the bin under the
support on the door and sliding into place.
The refrigerator has an interior light that comes on any time the
door is opened.
NOTE: The light is an LED which does not need to be replaced. If
the LED does not illuminate when the door is opened, call Service
to replace the light. See Assistance or Service for contact
information.
REFRIGERATORCARE
Base
You must remove the base grille to access the condenser coils for
cleaning.
To remove the base grille:
1. Open the refrigerator door.
2. Using a Phillips screwdriver, remove the two screws. Push
both tabs in toward the center to release the base grille from
the refrigerator.
"..............................................
_::::: %,_ ..........
d-d--r:::_
%
.......... ,.,<,.,<,.,<
< ,,,
A
B
A
A. Tabs
B. Screws
3. Remove the base grille.
To replace the base grille:
1. Open the refrigerator door.
2. Position the base grille so that both tabs align and the base
grille snaps into place. Replace the two screws. Tighten the
screws.
10
Publicidad
