Mounting The Camera; Tools Required - Waeco mobitronic RV-24 Instrucciones De Montaje Y De Servicio

_RV-24_RV-27.book Seite 31 Dienstag, 18. Mai 2004 11:25 11
RV-24, RV-27
Attach the cables securely in the vehicles to prevent tripping hazards.
Use cable binders, insulating tape or glue the cables in place.
Protect every through-hole made in the bodywork against water penetration,
e.g. by using a cable with a sealant and by spraying the cable and the the
cable sleeve with sealant.
Do not start sealing the through-holes until all installation work
has been finished for the camera, and the required cable lengths
have been established.
8

Mounting the camera

8.1

Tools required

For installation and assembly you will require the following tools:
Drill bit set (see 1 1, page 3)
Drill (see 1 2, page 3)
Screwdriver (see 1 3, page 3)
Set of ring or open-ended spanners (see 1 4, page 3)
Measuring ruler (see 1 5, page 3)
Hammer (see 1 6, page 3)
Centre punch (see 1 7, page 3)
To make and test the electrical connection, the following tools are required:
Diode test lamp (see 1 8, page 3) or voltmeter (see 1 9, page 3)
Insulating tape (see 1 11, page 3)
Cable bushing sleeves, if necessary
To fasten the cables you may require additional cable binders.
Mounting the camera
31