Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING INSTRUCTIONS
Point of Use
Remove excess soil with disposable cloth/paper wipe.
It is recommended that devices are cleaned as soon as is reasonably
practical following use.
Cleaning
Equipment: brush or cloth, running water, mild detergent
1. Rinse excess soil from instrument using warm (not hot) water.
2. Using a brush or cloth, apply detergent solution to all surfaces
(cord, bushings, plugs). Pay particular attention to recessed
areas in the instrument plug/bushing assembly.
3. Rinse thoroughly under clean running water.
4. Product must be thoroughly dried before storage and/or use.
Maintenance, Inspection and Testing
• Inspect cord insulation, male connector and female connector
for cracks, holes, burns, nicks, voids, etc. (do not use cords which
show any damage or deterioration).
• Connect cord to instrument and electrosurgical unit by grasping
connector bushings and fully seating conductive plugs.
Packaging
The Adaptor Cable Bipolar may be replaced in the original packaging
or similar after cleaning.
Disposal
1. Clean all external and accessible surfaces using the cleaning
instructions included in this DFU.
2. Use an electronic recycle facility to dispose of the Adaptor Cable.
a. Use of recycling service suppliers familiar with medical
electrical equipment is recommended, but not required. Do
not dispose of by incineration, burial or placement into a
common waste stream.
Post-Procedure
Any serious incident that occurs in relation to this device should be
reported to the manufacturer and relevant local regulatory authority.
WARRANTY
For device warranty information, visit (www.bostonscientific.com/
warranty).
EU Importer: Boston Scientific International B.V., Vestastraat 6, 6468 EX
Kerkrade, The Netherlands
Habib is a registered trademark of Boston Scientific Corporation or its affiliates.
All other trademarks are the property of their respective owners.
Black (K) ∆E ≤5.0
4
Publicidad
