PawHut D02-048V06 Instrucciones De Montaje página 6

Installing the chain link mesh
With two people, lift the chain link fabric roll (N) up into a standing position and
connect to the gate post with wire ties (K) and plastic ties (L) evenly spaced. Unroll
the fabric around the kennel frame.
Note: Use wire ties (K) to secure to gate side of frame loosely to keep in place while
unrolling. Add wire ties (K) as you move around. You can adjust wire ties (K) when
you get the fabric fully unrolled.
Chain link fabric (N) is cut to size but may need to be shortened for exact fit. You
may need to "cut" the fabric by removing a wire. Using pliers, unlock the knuckles at
the top and bottom of wire to be removed. Then, twist the wire out from the top.
Fasten fabric with wire ties (K). Place ties around bottom of kennel at 12 inch
intervals. Place ties around top at 18 inch intervals. Also secure fabric to all vertical
posts.
Notice
1.Need 2 people at least when you assemble to avoid the damage of steel tube.
2.Do not use this cage unless all bolts, screws and knobs are firmly secured.
3.Please use it on a flat hard ground.
4.No climbing and no revision on product.
5.Caution, hands pinching.
Warning:
A: Guarantee every post upright
B: Fasten (J) with Rand electric tool in the right direction.
C: Make sure every (J) assembled correctly before put your kennel in use.
5