Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Safety
EN Safety
0%
100%
IMPORTANT Do not use
with a dimmer switch.
IMPORTANT! Retain for future
reference: read carefully.
• These instructions are for your safety.
Please read through them thoroughly prior
to installation and retain them for future
reference.
• All fittings must be installed by a competent
person in accordance with local regulations
(IET wiring regulation BS7671).
• Check the pack and make sure you have all
of the parts listed.
• Remove all packaging, wrap etc from the
product.
• Decide on the appropriate location for your
product.
CAUTION: IP44 is guaranteed when
the product is properly installed and
sealed.
• The product must be securely fixed to the
mounting surface using the screws and
wall plugs supplied. The screws and wall
plugs supplied are suitable for "masonry"
only. Other fixings not supplied and must be
purchased.
• Take care not to drill into any pipes or
mains cables beneath the surface during
mounting holes preparation.
• Do not position or place the product
near to heaters, flame or any other direct
sources of heat.
216383_s1_s53-5059340231525-Blooma-A5-IM-V02.indb 2
216383_s1_s53-5059340231525-Blooma-A5-IM-V02.indb 2
IMPORTANT: The fixing point(s)
selected must be capable of supporting
the full weight of the light fitting.
• We recommend connecting this product
to an external / wall switch in order to
deactivate the motion detection function if
necessary.
• Wiring diagram is for reference only. Always
refer to the terminal marking for wiring.
Ensure that all electrical connections are
tight and that no loose strands are left out
of the terminal block.
• Never put anything on the product or hang
anything on any part of this product.
• Never use the terminal cables to bear the
product weight.
• When the product does not light after
installation:
> Ensure there is no electricity failure
> Ensure all the connections are secured.
2
21/10/2021 6:17 PM
21/10/2021 6:17 PM
Publicidad
