Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Safety
Symptom
The lights stay on
continuously.
The lights flash on and
off.
Sensor will not operate
at night.
216383_s1_s53-5059340231525-Blooma-A5-IM-V02.indb 5
216383_s1_s53-5059340231525-Blooma-A5-IM-V02.indb 5
Possible Cause
The unit may be suffering from false
activation.
Ensure the unit is not positioned to
detect unwanted objects e.g. cars /
people using roads / footpaths next
to your property. Occasionally, wind
may activate the sensor. (Sometimes
passages between buildings etc. can
cause a "wind tunnel" effect.)
The unit is operated in the mode of
the motion sensor being deactivated.
Heat or light from the bulbs may be
turning the sensor on and off.
Sensor is sensing reflected light from
the light fixture.
The level of ambient light in the area
may be too bright to allow operation
at the current LUX setting.
Wiring inside electrical came loose.
No power is being delivered to the
fixture.
Another light source is causing the
unit to think it is daylight.
Solution
Cover the sensor lens completely
with a thick cloth. This will prevent
the sensor from "seeing" anything.
If the unit now switches off after
the set time duration and does
not re-activate, this indicates that
the problem was caused by false
activation. Slightly adjusting the
direction / angle of the sensor head.
Relocate the unit.
To activate the motion sensor.
Relocate the unit, away from the light
source.
1. Change position of light head
aim light away from the reflecting
surfaces.
2. Relocate the unit to a different
location where it no longer causes
reflected light.
During the hours of darkness, adjust
the LUX control slowly anticlockwise /
clockwise (choose suitable one) until
the lamp just illuminates.
After turning off the fixture,
reconnect any loose wiring.
Check that circuit breaker and/or
wall switch power is on.
Turn off surrounding lights and/or
re-aim the sensor head.
5
21/10/2021 6:17 PM
21/10/2021 6:17 PM
Publicidad
