Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Safety
Technical Data
Supply
220-240 V~, 50/60 Hz
Voltage:
Max.
switching
1000 W for incandescent; 300 W for fluorescent; 150 W for LED (Max. 6 pcs).
capacity:
This product complies with conformity requirements of the applicable European
Regulations or Directives.
IP44
Splashproof.
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or local store for recycling advice.
Do not use with a dimmer switch.
xxWyy
xx-year; yy-week of the year.
Troubleshooting
Symptom
Light does not switch on
when there is movement
in the coverage area.
216383_s1_s53-5059340231525-Blooma-A5-IM-V02.indb 3
216383_s1_s53-5059340231525-Blooma-A5-IM-V02.indb 3
Possible Cause
The power switch is turned off.
The light fixture is not properly
attached to the mounting plate, if this
is a new installation (the pins are not
fully seated in the terminal block).
The circuit wiring is incorrect (if this
is a new installation).
The sensor is aimed in the wrong
direction. Detection zone not
properly targeted.
Check the lamp, if the light bulb has
failed, replace it.
Check if the total load of the lighting
system within the sensor's capacity.
Another light source is causing the
unit to think it is daylight.
Solution
Check that the power is switched ON
at the circuit breaker/internal wall
switch.
Re-install the light fixture to the base
and ensure the pins are fully seated
in the terminal block.
Check the wiring connections,
ensure no connections are loose.
Re-aim the sensor to cover the
desired area.
Ensure that the light bulb is seated
correctly in the lampholder.
Rearrange the whole lighting system.
Turn off surrounding lights.
3
21/10/2021 6:17 PM
21/10/2021 6:17 PM
Publicidad
