Publicidad
Idiomas disponibles
Idiomas disponibles
EN
15. troubleshooting
Problem
The pruning shears won't start
Strange operation
Excessive heating of the blade
Bad cutting surface
Not charging, red LED flashes
Two warning tones are given and
them are repeated 10 times
Three warning tones are given and
them are repeated 10 times
Four warning tones are given and
them are repeated 10 times
Ten warning tones are given and
them are repeated 10 times
5 second warning sound that repeats
10 times
Cause
Exhausted battery
Disconnected battery
Switch off
Switch failure
Bad connection
Switch failure
Blunt blade
Damaged blade
Insufficient lubrication
Higher friction force
Dirty blade
Blunt blade
Improper cutting strategy
Discharged battery
Battery not fully inserted into charger
Charger not connected to electricity
Dirty electrode
Battery in bad condition
Charger in bad condition
Failure of the cut opening placement
signal. The pruning shears are broken
Cut closure placement signal failure.
The pruning shears are broken
Fault in the motor winding. The pruning
shears are broken
Small maintenance
Big maintenance
14
Solution
Charge battery
Connect battery
Switch on
Repair the connection
Connection repair
Sharp the blade or replace it
Sharp the blade or replace it
Grease the blade
Grease the blade
Clean the blade
Sharp the blade or replace it
Read the instructions carefully
Charge battery
Re-insert the battery into the charger
Reconnect it
Clean the dirt
Replace the battery
Replace the charger
Send the pruning shears to the techni-
cal service for repair
Send the pruning shears to the techni-
cal service for repair
Send the pruning shears to the techni-
cal service for repair
Add oil to screw pin
Send the pruning shears to the techni-
cal service for repair, to add oil to the
gearbox and to carry out minor main-
tenance
Publicidad
