LG PDI Premium PQNUD1S40 Manual Del Propietario Y De Instalación página 33

• When setting the properties of the pulse-type gas meter (LHM1~LHM4)
C O N N E C T I O N :
S T A N D B Y P :
S E T M E T E R
W H M 1 : N O T U S E
W H M 2 : N O T U S E
W H M 3 : N O T U S E
W H M 4 : N O T U S E
L H M 1 : N O T U S E
L H M 2 : N O T U S E
L H M 3 : N O T U S E
L H M 4 : N O T U S E
* L H M L / P U L S E
1 . N O T U S E
2 . 1 L / P U L S E
3 . 2 L / P U L S E
C O N S U M E U N I T
1 . O D U M A S T E R
2 . O D U S L A V E
I N D O O R A D D R E S S
( S T A R T ) → ( E N D )
( 0 0 ) → ( 0 0 )
L H M 1 : 1 0 L , O D U , 0 0 - 0 0
L H M 2 : 1 0 L , O D S , 0 0 - 0 0
L H M 3 : N O T U S E
L H M 4 : N O T U S E
After setting every gas meter, press the menu button to save the settings, and then move to the
initial screen.
CAUTION
!
• The GHP master outdoor unit and the GHP slave outdoor unit must have the same range
of indoor unit addresses.
• The gas amount of the indoor unit is the sum of the value of the master gas distribution of
outdoor unit and the value of the slave outdoor unit gas distribution.
M A S T E R
On the initial setting screen, press the (▼) button and
A U T O
the screen will be switched to the wattmeter / gas
D O W N
meter property setting screen.
D O W N
On the wattmeter property setting screen, press the
(▼) button and the screen will be switched to gas
meter property setting screen.
When the item of the wattmeter you want to set is
blinking, press the SELECT button, and the screen will
be switched to the detailed setting screen.
Set gas consumption per pulse ' Set the connected indoor unit
S E L E C T *
address in order.
- Set gas consumption per pulse (LHM L / PULSE SELECT).
: Please enter a value shown in the gas meter as the gas con-
sumption recognized per pulse.
D O W N
- Gas consumption device settings (CONSUME UNIT SELECT)
: Please check the type of outdoor unit installed with a gas
S E L E C T
meter and select an appropriate item.
※ If a separate gas meter is installed in the GHP slave outdoor
unit, select ODU SLAVE.
- Set the connected indoor unit address (INDOOR ADDRESS SET).
: Enter the address of the indoor unit connected to the gas
meter.
※After the initial installation, address setting of indoor unit
S E T
- Set connected indoor address (INDOOR ADDRESS SET)
: Enter the indoor address connected to applicable wattmeter.
After setting the item, press the SELECT button to save the
settings, and then move to the next step.
Configuration information is reflected in the
detailed setting window.
SETTING AND USING METHOD
connected to each port shall not be changed.
If it is changed, previous data cannot be used.
33