Proxxon LHW/A Manual De Instrucciones página 15

Warning!
Depending on the operating conditions, the
emissions that actually occur may deviate from
the values given above!
This applies in particular depending on the
workpiece to be machined and the insert tool
(especially its wear condition). Unsuitable
workpieces or materials, poorly maintained
tools, too high a feed rate or unsuitable insert
tools can signifi cantly increase the vibration
load and noise generation.
To more accurately estimate the actual vibra-
tion and noise load, also take the times into
consideration where the device is switched off,
or is running but is not actually in use. This can
clearly reduce the vibration and noise load ac-
ross the entire work period.
Warning!
• Ensure regular and proper maintenance of
your tool
• Stop operation of the tool immediately if ex-
cessive vibration occurs!
• Unsuitable bits and cutters can cause exces-
sive vibration and noises. Only use suitable
bits and cutters!
• Take breaks if necessary when working with
the device!
4 Scope of delivery
LHW/A (29815):
1 pc. Battery-powered
grinder LHW/A
1 pc. Charger
1 pc. Lithium-ion battery
1 pc. Operating instructions
1 pc. Safety guidelines
1 pc. Storage case
1 pc. High-grade corundum sanding disc (K 60)
1 pc. Fan sander (K 100)
1 pc. Cutting disc (fabric reinforced)
1 pc. Allen key
long-neck angle
LHW/A (29817):
1 pc. Battery-powered
grinder LHW/A
1 pc. Operating instructions
1 pc. Safety guidelines
1 pc. High-grade corundum sanding disc (K 60)
1 pc. Fan sander (K 100)
1 pc. Cutting disc (fabric reinforced)
1 pc. Allen key
5 Commissioning and operation
Charging the battery (Fig. 2 and 3)
Caution!
Before starting up, read the warning instruc-
tions and the labels attached to the charger and
the battery!
Caution!
Please note that your Proxxon power tool may
only be operated with the appropriate Proxxon
battery and that the charger is to be used exclu-
sively for the charging of these batteries.
Furthermore, no other charger may be used
to charge the Proxxon battery: The respective
Proxxon components are optimally coordinated.
Please note: The device, battery and charge
are also separately available at retailers!
Please note:
Only charge the battery at an ambient tempera-
ture of 10 to 40°C!
When delivered, the battery is partially char-
ged and must be charged completely before
commissioning the device. To do so, proceed
as follows:
1. Insert the plug of the charger.
2. Insert battery 1 in the charger 2 as shown
in Fig. 2.
3. The yellow light-emitting diode 3 signals
the charging process. When completed, the
green light-emitting diode 4 lights up.
4. Remove the completely charged battery
from the charger.
long-neck angle
- 17 -