Genesis GBDS450 Manual Del Operario página 6

SPECIFIC SAFETY RULES FOR BELT/DISC SANDERS
WARNING:
(GAINED FROM REPEATED USE) REPLACE STRICT ADHERENCE TO PRODUCT
SAFETY RULES. If you use this tool unsafely or incorrectly, you can suffer
serious personal injury!
• Make sure the belt/disc sander is on a firm, level surface and
properly secured
Unplug the tool before making adjustments, repairs, maintenance
•
or storing.
• Always switch off the tool before unplugging it
when replugging the tool into a power source.
• Wear eye protection and dust mask.
• Do not operate the sander
manual's instructions.
• Do not use the tool
immediately replaced by an authorized service center and the machine not used under repairs
are completed.
• Always support work piece with miter gauge, work support or
table.
• Keep fingers away from pinch points
• Maintain 1/16 in. (1-2mm) clearance between table and sanding belt
or disc.
• Maintain proper adjustment of sanding belt tension and alignment.
• Never sand more than one piece at a time.
• Always feed the work piece from left to right
belt is rotating.
• Use extra caution with large,
to sand a piece too small to hold by hand.
• Avoid awkward operations and hand positions
sudden slip that could cause your hand or fingers to move into the sanding belt or disc.
• Never stand in line with the path of work piece.
• Do not operate in rain or in damp locations.
• Grounding required.
Belt/Disc Sander
Operator's Manual
DO NOT LET COMFORT OR FAMILIARITY WITH PRODUCT
to avoid injury from unexpected movement.
until it is assembled and installed according to this
if the switch does not turn it on and off. Defective switches should be
very small or awkward work piece. Never use this tool
SAVE THESE INSTRUCTIONS
to avoid accidental starting
between housing and sanding belt or disc.
against the direction the sanding
where an unexpected or
GBDS450