Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical connection
When making the connection to the electrical mains, check that the voltage is the same as the value
stated on the nameplate, and that the electrical system wires are of large enough gauge to withstand
the load also stated on the nameplate.
The plug used for the connection must comply with standards and be suitable for the appliance's
power absorption.
If the appliance is connected directly to the mains, an omnipolar circuit breaker with contact gap of at
least 3 mm, rated for the load and compliant with the relevant regulations, must be installed between
the appliance and the mains.
Never use reducers, adapters or diverters for the mains connection, since they may
overheat and cause burns.
The appliance must be earthed. The manufacturer declines all liability for failure to
comply with this requirement. ( Fig. 8 )
When replacing the power lead, use a cable with the same characteristics as the original, suitable for
the load and the temperature (such as T90°C) involved; the replacement must be ordered from the
service centre. At the end of the cable for connection to the appliance, the green-yellow earth wire
must be 20 mm longer than the other wires.
Refer to the table below for power lead dimensions.
THE MANUFACTURER ACCEPTS NO LIABILITY IN CASE OF FAILURE TO COMPLY WITH THE
ABOVE INSTRUCTIONS
AND WITH NORMAL ACCIDENT PREVENTION STANDARDS.
Hob type
With 1000W electric plate
With 1500W electric plate or two electric plates
Size
3 X 0.75 mm2
H05 V2V2-F
3 X 1,5 mm
2
H05 V2V2-F
17
Publicidad
