Kärcher IVM 60/36-3 H ACD Manual Del Usuario página 31

WARNING
Danger from dust that is harmful to your
health
Respiratory sicknesses through inhalation
of dust.
Do not use the main filter element after re-
moving it from the device.
Permanently installed filters may only be
replaced by an expert in a suitable area,
e.g. a decontamination station.
1. Secure the device with the parking
brakes.
2. Switch off the device at the power
switches.
3. Pull out the mains plug.
4. Unlock and remove the suction head.
5. Unlock and remove the spacer.
6. Remove the contaminated main filter.
7. Immediately after removing the contam-
inated main filter from the unit, place it in
a bag and seal the bag tightly.
8. Dispose of the contaminated main filter
according to legal requirements.
9. Check the sealing ring for damage.
10.Remove any dirt deposits from the clean
air side.
11.Fit the new main filter in reverse order.
Make sure that the filter hold-down de-
vice is centred in the filter pockets.
12.Fit and lock the spacer.
13.Fit and lock the suction head.
Replacing the H filter
1. Secure the device with the parking
brakes.
2. Switch off the device at the power
switches.
3. Pull out the mains plug.
Illustration P
4. Unlock and lift the suction head.
5. Release the vacuum hose at the suction
head and remove the suction head.
6. Unscrew the hexagon screw anticlock-
wise using a suitable tool.
7. Remove the seals and the contaminated
H-filter from the suction head.
8. Immediately after removing the contam-
inated H-filter from the unit, place it in a
bag and seal the bag tightly.
9. Dispose of the contaminated H-filter ac-
cording to legal requirements.
10.Remove any dirt deposits from the clean
air side.
11.Fit the new H filter in the reverse order.
Make sure that the seals and the vacu-
um hose are correctly seated.
12.Apply a suitable agent (e.g. Loctite 243)
to the thread of the hexagon screw to
prevent unintentional loosening.
13.Tighten the hexagon screw clockwise.
14.Fit and lock the suction head.
Replace dust bag
1. Secure the device with the parking
brakes.
Illustration C
2. Pull the bow handle up.
The dirt receptacle is unlocked and low-
ered.
Illustration D
3. Pull the dirt receptacle out of the device
by the bow handle.
Illustration I
4. Turn up the dust bag.
5. Seal the dust bag tightly with the cable
tie.
6. Remove the dust bag.
7. Dispose of the dust bag in accordance
with statutory regulations.
Illustration E
8. Insert the new dust bag in the dirt recep-
tacle and carefully place it against the
container wall and the container floor.
9. Fold the edge of the dust bag over the
edge of the dirt receptacle to the outside.
WARNING
Improper handling when locking the dirt
receptacle
Risk of crushing
Under no circumstances should you hold
your hands between the dirt receptacle and
filter ring or allow them to come close to the
lifting mechanism while locking it.
Lock the dirt receptacle by operating the
bow handle with both hands.
English 31