Taurus AIRBRUME 2500 Instrucciones De Uso página 13

• Make sure the floor on which the appliance is installed/
placed is moisture resistant.
• Do not place the steam outlet close to furniture, walls,
TV or any other appliance that could be damaged by
the moisture. Excessive use or misuse of the appliance
could over-saturate the air humidity and cause water to
condense around the humidifier.
• Do not use the appliance when relative air humidity
exceeds 55%. Using a hygrometer, regulary check that
the room's relative humidity is between 40%-60%.
• The recommended comfortable room temperature is
from 18-22 ºC. Use the appliance within this range
temperature. Below this temperature, the air in the room
cannot absorb more moisture and condensation is more
likely.
• Do not leave the appliance unattended when switched on.
• Do not use essential oils, these affects the correct
function of the appliance.
INSTALLATION
• Be sure to remove all packaging material from inside the
appliance.
• Ensure that the mist fan is switched off from the supply
mains before start any installation or assembly operation.
• The appliance should be used with its wheels attached.
ASSEMBLING THE BATTERIES
• This appliance uses a pair of 1,5V AAA batteries.
• Caution: During the handling of batteries, do not touch
both poles at the same time, as this will provoke the
partial discharge of the stocked energy therefore affecting
longevity.
• Remove the cover of the battery compartment.
• Check that the plastic covering that protects the battery
has been removed (some batteries are sold with a
protective covering).
• Put the battery in its compartment, respecting the polarity.
• Replace the cover of the battery compartment.
• It is essential that the batteries should always be the
same kind and the same charge. Never mix alkaline
batteries with Carbon-Zinc ones and/or rechargeable
ones.
• Non-rechargeable batteries are not to be recharged.
• DO NOT charge rechargeable batteries while they are
still in the appliance as it may cause internal gas or heat
generation, resulting in an explosion or possibly a fire that
could cause serious injury or property damage.
• To preserve battery life, remove the batteries when it's not
being used, and is not expected to be used for extended
periods of time.
ASSEMBLING THE BASE
• Fit the base with the column and secure it with the screws
provided inserting the cables inside. (Fig. 1).
• To fix the base into the appliance, place the appliance
face down.
• Stand the appliance up again to check that the base
stands properly.
ASSEMBLING THE WHEELS
• To assemble the wheels, place the appliance face down.
• Place the wheels by pressing them into their housing.
• Lift the appliance again and check that the wheels work
correctly.
ASSEMBLIG THE WATER TANK
• Put the water tank in its place. (Fig. 2).
ASSEMBLING THE GRILL AND THE PROPELLER
• Place the main part of the appliance, connecting the cable
first, with the base and fixing it with the provided screw.
(Fig. 3.1).
• Fit the rear grill (G) on the motor body (H), matching their
fitting points.
• Tight the grill nut (F) that attaches the grill and make sure
of a correct setting.
• Fit the propeller (D) on the motor shaft (I).
• Tight the propeller nut (C) that attaches the propeller and
make sure of a correct setting. (Fig. 3.2).
• Fit the front grill (B) front the rear grill (G). (Fig. 3.3).
• Fix the front grill by turning around its fixing belt (E) and
tight the security screw by using a screwdriver. (Fig. 3.4).
• Check the correct rotation of the propeller.
• Connect the mist tube (J) to the mist diffuser (A). (Fig.
3.5).
FILLING WITH WATER
• Disconnect the appliance from the mains before filling the
water tank.
• Disconnect the mist tube from the water tank lid.
• Remove the appliance's water tank. (Fig. 4).
• Open the lid.
• Fill the water tank with cold water taking care to observe
the MAX level. (Fig. 5).
• Close the lid.
• Put the water tank back into its housing, ensuring that it is
inserted properly.
• Connect the mist tube. (J).