Rottner KEYO Guia De Inicio Rapido página 4

ENGLISH
GB US
USER INSTRUCTIONS
KEYO
ATTENTION: Please read this operating instruction carefully, before you operate the lock or you try
to set a new code for the electronic lock. We do not accept any liability for functional disorder be-
cause of faulty switch over or use of violence or improper use and neither for damage nor for loss
of property which could be put down i.e. to the not proper closing of the safe.
Never keep the emergency key inside.
General remark:
a- Each time a button is pressed properly a signal tone will sound. In between pushing the buttons a
maximum time of 30 seconds is allowed.
b- Any correct code entry is confirmed by a double signal. In case a wrong code is entered the sig-
nal will sound 3 times.
c- When changing personal codes, always do this with the door of the key cabinet open.
d- In case something goes wrong, you then will still have access to your belongings.
1. OPENING THE CABINET FOR THE FIRST TIME
1.1 Remove the cover at the front below the door handle.
1.2 Insert the emergency-key that comes with the key cabinet, and turn it clockwise.
1.3 Now you can open the key cabinet, by turning the door handle clockwise.
1.4 Turn the emergency-key in its original position and take it out. Never keep the emergency-key
inside the key cabinet.
1.5 On the inside of the door, remove the cover of the battery drawer.
1.6 Insert four 1,5 V AA batteries (Alkaline). Pay attention to the polarity! Close the battery drawer
(safe was delivered without batteries).
1.7 The electronic lock of the key cabinet is delivered with a preset Mastercode (- 1 - 2 - 3 - 4 - 5 - 6 -).
Before you start using the key cabinet, we strongly advice you to change the Mastercode and also
set a personal Usercode. Write down the codes you want to use, before you start reprogramming.
Please don't use any codes that are related to your date of birth, etc. Keep the written down codes
and the emergency key in a safe place. Never keep the emergency-key and the codes inside the
gun cabinet.
2. PROGRAMMING OF THE NEW USERCODE
2.1 Open the key cabinet as described in point (1).
2.2 Press the red button on the inside of the door.
2.3 You will hear 2 sound signals. You now have 5 seconds to start the programming of the new
Usercode.
2.4 By using the keypath, type in the new Usercode. Because of security reasons, we advice you to
enter a code with 3 to 8 digits. Confirm the code by pushing the button „#" on the key path on the
outside of the door.
2.5 A correct programming of the code is confirmed by 2 sound signals.
2.6 You have now successfully programmed the Usercode.
4 KEYO