Publicidad
M000-M255
Change the Y-axis motor running speed (M000~M255) up or down, and press EN-
TER to save.
FAN0-FAN1
Fan setting: FAN0 will start the fan when it is powered on, FAN1 will start the fan
when it reaches the set temperature protection point, and press ENTER to save.
T040-T070
Change the temperature parameter up or down (40°~70°), press the enter ENTER
to save.
Send
Send the factory setting parameters of the machine up or down to all other lamps
connected in parallel with three-core signal lines; confirm the sending parameters
and press the menu key for 5 seconds to exit, or deny the parameters and press
the ENTER key to cancel the sending.
DMX512 CONSOLE
After power on, set the address codes of all fixtures, and then connect all fixtures in parallel to the
DMX512 console via three-core signal cables. The address codes will stop flashing, indicating that
the DMX512 console signal has been sent to the fixtures. Use DMX512 to control the fixtures.
See the DMX channel charts on page 2-3 of the manual.
MODE EFFECT
See the MODE channel chart on page 3-6 of the manual.
Tip: Mode code 9~120, you can push and pull RGBW to change the background color.
SPECIFICATONS
Input voltage ................................................................................................................... 100-240V~ 50/60Hz
Consumption ............................................................................................................................................. 180W
Light source ......................................................................................................... 10x 15W RGBW 4-in-1 LEDs
Operating modes ..................................................................................... DMX512, auto, master-slave, RDM
DMX channels ................................................................................................................................... 7 / 13 / 43
Dimmer ............................................................................................................................. Linear 0-100% 32bit
Strobe frequency .................................................................................................................................... 1~30Hz
IP .................................................................................................................................................................. IP20
Dimensions .......................................................................................................................... 980 x 180 x 80mm
Weight ........................................................................................................................................................ 6.1kg
IMPORTANT NOTE: Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
www.afx-light.com
11
EN
Publicidad
