Thermador HPWB30 Manual página 6

LIGHTS
_ CAUTION: Should read before replacing the lamps, switch power off at service panel and
lock service panel disconnecting means to prevent power from being switched on accidentally.
NOTE: Turn off the lights and fan. Allow the lights to cool before handling. If new lights do not
operate be sure lights are inserted correctly before calling service.
Note! Lamps are not supplied and must be purchased separately.
Replace Lights
• Remove the damaged light (twist counter clockwise) and replace with a new 120 Volt, 50 Watt
(maximum) 50 ° halogen light made for a GU10 base, suitable for use in open luminarie.
CLEANING THE HOOD
• Always use the mildest cleaner that will do the job. Use clean, soft cloths, sponges or paper towels.
• Rub stainless steel finishes in the direction of the grain. Wipe area dry to avoid water marks.
• After cleaning, place all parts in their proper positions before using.
The cleaners recommended below indicate a type and do not constitute an endorsement. Use all
products according to package directions.
Care and Cleaning Chart
A Anodized
Aluminum
surfaces
B Aluminum
Mesh Filters
C Plastic
surfaces
D Painted sur -
faces
Stainless
Steel Surfaces
Top cap is not removable. Wash top and underside with hot sudsy water.
Rinse and wipe dry or apply Fantastic ® or Formula 409 ®first to a clean
sponge or paper towel and wipe clean. DO NOT USE powdered cleansers
or steel wool pads.
Clean filters in the dishwasher or by agitating in sudsy water. Ensure that
there is no soil trapped in the fine mesh. Dry the filters before reinstalling
them.
DO NOT REMOVE control buttons. Wipe with a moist soapy sponge. Rinse
and dry.
For general care, wipe the outside of the hood with sudsy water or household
cleaners such as Fantastic or Formula 409, rinse well and dry with a clean
soft cloth to avoid water marks.
DO NOT USE powdered cleansers or steel wool pads.
Wipe and dry stainless steel in the same direction as the grain. Avoid using
too much pressure, which may mar the surface. To remove finger prints and
give added shine, use cleaners such as Stainless Steel Magic. Do not allow
any cleaning compounds to remain in contact with stainless steel for
extended periods.