cecotec CARPET&SPOT CLEAN LIBERTY Manual De Instrucciones página 57

3. ASSEMBLY
1. Insert the hook as shown in figure 2.
2. Insert the cleaning accessory you wish to use into the hose as shown in figure 3.
3. Insert the hose hook as shown in figure 4.
4. Insert the battery as shown in figure 5.
Filling up the water tank
1. Remove the clean water tank from the main body of the device, to do so slide the clean
water release tab and remove the tank in the direction of the arrows shown in figure 6.
2. Turn the clean-water tank, loosen the cap, and fill the tank with clean water. The maximum
water capacity is marked on the tank as "MAX", do not exceed it under any circumstances.
Fig. 7-8
3. Screw the cap and install the clean-water tank back into the main body. Fig. 9-10
Attention
After filling the tank with water, you must tighten the cap correctly to avoid leakage.
-
You can add low-foam detergent to the clean-water tank.
-
After using your device, you must empty the remaining water in the clean-water tank to
-
avoid leakage and mould formation.
Do not shake the clean-water tank during installation, as it could cause water leakage.
-
Upholstery cleaning accessory
Press the button under the head to switch between the brush head and the plastic head.
4. OPERATION
1. Read the label of the fabric you wish to clean to check that it is suitable for this cleaning
process.
2. Plug the appliance into a power supply.
3. Press the power button to turn the device on. Fig. 11
4. Press and hold the water release button to spray clean water. Spray clean water on the dirt
to bring it to the surface. Fig. 12
5. Press the suction inlet on the dirt to bring water and dirt to the surface and vacuum them.
Fig. 13
6. Stop spraying clean water and vacuum the waste water. After using the device, dry the
surface with a dryer or let it air dry. Fig. 14
7. Switch off the device by pressing the power button.
8. Disconnect the appliance from the power supply.
9. Empty the clean and waste water from the tanks and clean the waste-water tank.
10. Connect the self-cleaning head and activate it for 30 seconds. Fig. 15
CARPET&SPOT CLEAN LIBERTY
ENGLISH
57