cecotec CARPET&SPOT CLEAN LIBERTY Manual De Instrucciones página 59

tank; if you continue using the tank after the waste water has exceeded the maximum
water level, the float valve will automatically stop the machine vacuuming water.
5.3. Cleaning the clean-water tank
1. Remove the clean-water tank in the arrow direction, as shown in the assembly section.
2. Loosen the cap and empty the remaining water.
3. Tighten the cap of the clean water tank again and install the empty tank.
4. Press the power button to turn on the device.
5. Press the water release button to empty the remaining water in the device.
6. When it stops releasing water, turn off the device and unplug it from the mains.
5.4. Cleaning the suction nozzle
1. Press the suction nozzle release button and separate it from the hose bracket. Fig. 20
2. Remove the front cover by lifting it with your finger. Fig. 21
3. Rinse the suction nozzle. Fig. 22
4. Install the suction nozzle cover again. Make sure the pins are correctly placed in the holes
and press these parts until they click. Fig. 23
5.5. Charge the appliance
Connect the charger to the device as shown in figure 24.
6. TROUBLESHOOTING
If you observe any problem, carefully read this manual and try any possible solutions before
contacting Cecotec Technical Support Service.
Problem
The appliance does not work
and the switch is on.
When pressing the water
release button, there is no
water or little water released.
Possible causes
The plug is not correctly
connected and loose, so it
does not make contact.
The internal line or power
cord are broken.
The tip is clogged.
The bracket or pump are
damaged.
Possible solutions
Turn off the device and
connect it again to the
mains.
Contact the Technical
Support Service of Cecotec.
Remove the suction nozzle
and clean it with clean
water.
Contact the Technical
Support Service of Cecotec.
CARPET&SPOT CLEAN LIBERTY
ENGLISH
59