HomeMatic HmIP-WTH-2 Manual De Instalacion Y Uso página 31

Start-up
6.2 Installation
Please read this entire section
before starting the installation.
You can use the supplied clip-on frame
(A) to mount the wall thermostat or ea-
sily integrate it into an existing switch
(see „6.2.4 Installation in multiple combi-
nations" on page
If you want to mount the wall thermo-
stat with the supplied clip-on frame,
you can use
• the supplied double-sided adhesive
strips or
• the supplied screws
to fix it to a wall.
You can also mount the wall thermos-
tat on a flush-mounting box.
6.2.1 Adhesive strip mounting
For mounting the assembled wall ther-
mostat with the adhesive strips, please
proceed as follows:
• Choose a site for installation.
Make sure that the mounting sur-
face is smooth, solid, non-distur-
bed, free of dust, grease and sol-
vents and not too cold to ensure
long-time adherence.
• Fix the adhesive strips (G) on the
back side of the mounting plate
(F) in the provided area. Make sure
that you can read the letters on the
back side (H) and that the clips on
the mounting plate latch into the
openings on the wall thermostat.
33).
G
H
• Remove the protective film from
the adhesive strips.
• Press the assembled wall thermos-
tat with the back side to the wall in
the position where it should subse-
quently be attached.
6.2.2 Screw mounting
For mounting the wall thermostat by
screws, please proceed as follows:
• Choose a site for installation.
Make sure that no electricity or
similar lines run in the wall at this
location!
• Position the mounting plate (F) on
the desired site on the wall. Make
sure that the arrow on the moun-
ting plate is pointing upwards.
31