Publicidad
Idiomas disponibles
Idiomas disponibles
SHIELD ROTARY TOOL INSTALLATION INSTRUCTIONS
Step 1. Remove the housing cap (A) from the end of the tool and set housing cap aside. The original housing
cap must be reinstalled when this attachment is not used (Fig.1).
Step 2. Screw the shield onto the tool using the lock nut B (Fig.2).
Step 3. Position the shield such that it will redirect debris, sparks, and dust away from the user using the
positioning tabs C (Fig.3).
Using the Shield Rotary Tool Attachment:
Always turn the tool off before adjusting position, changing accessory and removing attachment. Rotary
Tools cut, sand, grind, and polish in many directions. To accommodate the Rotary Tool's maneuverability, the
shield can be quickly positioned and repositioned with a turn to the right or left. To extend the life of the shield
periodically clean with a soft bristle brush or compressed air.
Using the Shield Rotary Tool Attachment:
Always turn the tool off before adjusting position, changing accessory and removing attachment. Rotary
Tools cut, sand, grind, and polish in many directions. To accommodate the Rotary Tool's Maneuverability, the
Shield can be quickly positioned and repositioned with a turn to the right or left .To extend the life of the Shield
periodically clean with a soft bristle brush or compressed air.
FLEXIBLE DRIVER ATTACHMENT
SAFETY RULES FOR FLEXIBLE DRIVER
•
Do not operate the flexible shaft with a sharp or multiple bends. Ensure
that there are no sharp residual bends or kinks in the Flexible Driver
before the operation. Over bending the shaft can generate excessive
heat on the jacket or hand piece and may cause the Flexible Driver to
disengage from the tool.
•
The minimum recommended bend radius is 6".
•
Always hold the hand piece firmly in your hands during the start-up. The reaction torque of the motor, as it
accelerates to full speed, can cause the shaft to twist.
•
Not for use with router bits or other large diameters (1" or larger) bits. Large diameter bits can cause
kickback and loss of control when used with the Flexible Driver. Do not remove end ferrule while tool is
running. The cable will become loose from the jacket and will uncontrollably whip or lash around.
WWW.FORNEYIND.COM
11
Publicidad
