Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Diagram of Flexible Driver
1. Remove the shaft collar.
4. Raise the handle end of the flexible shaft & shake gently until the
inner flexible shaft protrudes from the fitting collar.
5. Insert the inner flexible shaft into the square collet.
a. Screw the flexible shaft fitting onto the rotary tool.
6. Insert the L pin into the hole on the handle.
8. Tighten collet nut and check all fittings to ensure they are securely fastened.
DIRECTIONS FOR USE
•
With small milling cutters / grinding pins: Use a high speed.
•
With large milling cutters / grinding pins: Use a low speed.
•
Precision work / engraving: Hold the drive unit like a pen.
•
Rough work: Hold the drive unit like a hammer.
TIPS:
•
Exert only moderate pressure on the workpiece and allow the tool to work at a consistent speed.
•
You will not finish your work sooner by exerting heavy pressure. On the contrary, heavy pressure will
cause the drive unit to slow down or stop and will overload the motor.
•
For your own safety, use a vise or screw clamp to secure workpieces.
2. Loosen the collet nut.
7. Loosen collet nut then insert shank of
accessory into collet.
WWW.FORNEYIND.COM
3. Tighten square collet nut.
12
Publicidad
