Publicidad
Idiomas disponibles
Idiomas disponibles
4. Initial use
Place the premium boot cleaner on a level, non-
slip and horizontal surface.
The premium boot cleaner can be fixed to the
ground using the floor mounting C accessory.
Do not connect the boot cleaner directly to the pub-
lic drinking water supply.
Observe the regulations of the water supply com-
pany.
The connection is made via a ½" water hose.
Fasten the hose to the hose nozzle B with a hose
clamp. Tighten the hose clamp with 2 Nm.
The dirty water can be drained off on both sides
(1½" thread).
Close the unused drain J with the plug supplied.
5. Use
Do not expose the premium boot cleaner to direct
sunlight for long periods.
Excessive heating can lead to deformation of the
high-quality plastic housing.
Suitable operating conditions are 0°C to max.
+40°C.
If there is a risk of frost, disconnect the boot
cleaner from the water supply and empty it.
Ensure water supply to the premium boot cleaner
is open before use.
The water supply of the stationary brushes is con-
trolled by the ball valve E.
The flow at the hand brush F is regulated and
shut off with the dosing lever.
Water is applied to the brushes at an angle from
above through 3 holes on each side of the water
outlet pipe G.
The wastewater generated must be disposed of in
accordance with local environmental regulations.
When using the premium boot cleaner, make sure
that it is standing securely, use integrated handles
D.
The sole and sides of the boots are cleaned with
the 3 stationary brushes, H + I.
Close the ball valve E after use.
To clean the boot shaft, also use the hand brush
F.
non-slip surface
To do this, the boot can be supported on the non-
slip support surface.
To clean the hands, use outlet Lwith the hand
brush F open.
Ensure that the water supply to the premium boot
cleaner is closed after use.
GB
Dosing lever
11
Publicidad
