Publicidad
Idiomas disponibles
Idiomas disponibles
11. Installation of the pool wall
WARNING: An incorrectly installed metal sheet could cause the pool to collapse. Do not install the metal sheet in windy
weather.
NOTE: For some larger sized pool models, the wall is composed of two half-walls in order to facilitate handling (for some
models, the weight of the wall may exceed 100 kg). This does not change the way in which the wall is installed.
Use the ladder to enter and exit the pool during installation. Take the pool wall
out of the box and place it on top of the box or on a board for easy unravelling.
Ensure that the skimmer cut out is placed on the top part of the metal sheet,
with the opening positioned facing the prevailing wind, so that the wind
blows any impurities towards the skimmer.
We recommend installing the metal sheet wall so that the skimmer and discharge
nozzle cut outs are located on a rounded side of the pool and not on a straight
Skimmer cut outs and
side of the pool. Begin by pushing the metal sheet into the groove of the profiles
discharge nozzle
and continue until the wall is completely unrolled.
Start in the middle of a connecting plate so that the bolts are hidden by a
vertical post. Join the extremities of the metal sheet using the bolts and washers.
Inside
The screw heads must be on the inside and the nuts on the outside. Ensure
Sides
that all the bolt holes are used. It is very important for all the bolts to be
adequately tightened to ensure a solid join. To protect the liner, stick a protection
band (duct tape) over the screws on the inside of the pool.
IMPORTANT: Increase the stability and rigidity of the metal sheet by
Screw
temporarily placing the top metal profiles and the vertical posts (round part)
as you go along.
Nut
Washer
On the lower part, fix the posts to their connecting plate using 2 screws; on the
upper part, fix the posts to their connecting plate with 3 loosely tightened screws.
Exterior
OSMOSE White Oval
95
Assembly Guide 880118-rev F
Publicidad
