Publicidad
Idiomas disponibles
Idiomas disponibles
15. Filtration
IMPORTANT: All filtration systems comply with installation standard NF
C 15-100 stipulating that all electrical devices located within 3.50 m of
the pool and freely accessible must be powered by very low voltage (12
V).
Any device powered with 220 V must be located at least 3.50 m from the
edge of the pool. This means that:
■ This means that for a filter, the device must be installed more
than 3.50 m from the pool,
■ For filtering skimmers (depending on the kit), the transformer
must be located more than 3.50 m from the pool.
NOTE: All threaded connectors should be attached with Teflon
tape, wound in the opposite direction of the thread.
Seek advice from the manufacturer for any modifications to one or more
filtration system elements.
Depending on the filter media used, refer to the quantities listed opposite
to be put in the tank.
TO ASSEMBLE THE FILTER SYSTEM, REFER TO THE USER GUIDE IN THE FILTRATION BOX
15.1. Installing the discharge nozzle
When assembling pools with a filtration system operating through the
pool wall, the following procedures must be carried out:
■ When the pool's water level reaches 5 or 6 cm from the discharge
nozzle, install the nozzle as follows (see figure 1).
■ Cut out the part of the liner covering the discharge nozzle using a
metal cutter (see figure 2) and pull the cut out liner back onto the pool
wall. You may find it helpful to place a piece of flat wood on the other
side of the liner to the cut out to keep it down.
■ From the inside of the pool, install the rubber joint and the discharge
nozzle (see figure 3) and screw in from the outside of the pool with a
clamping nut.
■ Screw the connector or stopper valve (depending on the model).
■ Install the ringed hose and the hose clamp.
■ Connect the corrugated pipe to the valve (return to pool) from the filter
(threaded connector with Teflon tape and ring clamp).
Discharge
nozzle
Figure 3
Pool
interior
OSMOSE White Oval
Seal
Liner
Filtration size
Filtration 4 m³/h
Filtration 6 m³/h
Filtration 8m³/h
Filtration 10 m³/h
Filtration 12 m³/h
Water level
Pool interior
Steel sides
Adjusting nut
Pool
exterior
99
Discharge
nozzle
Sand
Aqualoon ball
20 kg
560 g
35 kg
980 g
75 kg
2100 g
75 kg
2100 g
75 kg
2100 g
Figure 1
Liner
Discharge
nozzle
Figure 2
Assembly Guide 880118-rev F
Skimmer
Steel sides
Adjusting
nut
Threaded
connector
Rubber seal
Publicidad
