Publicidad
Idiomas disponibles
Idiomas disponibles
5....-05-MRC 528 P NEU
To activate the wake-up function, please push the function switch (9) towards the
GB
ON position. A bell lights up in the display (5). Below this you will see the letters
„Zz". When the set time is reached an alarm goes off for up to one minute. To
switch the alarm off, move the ALARM switch (9) on the back of the device to the
OFF position.
1. With this device it is possible to project the time on to the wall or the ceiling.
2. To do so, please push the projection switch (6) to the ON position.
3. You can swivel the projector (8) forwards and backwards. Please note that if
you rotate it to the back the time is upside down and back to front.
4. An adjustment wheel (FOCUS) for adjusting the sharpness of the projected dis-
play is located on the projection lens.
Please note that the projection is only visible at night.
The automatically set alarm function can be shut off for approximately 8 minutes
with the SNOOZE key (7). The letters "Zz" flash in the display (5). If you press the
ALARM button (3) the "Snooze" function is switched off completely until the next
day.
If the PROJECTOR switch (6) is turned to OFF, you can press the LIGHT button (7)
to activate the projector and the lamp in the display for a few seconds.
•
Remove the plug before cleaning.
•
Clean the appliance with a slightly humid cloth without any additives.
•
Do not dip the appliance in water.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
18
16.12.2003
Projection
Automatic Alarm Interval
Cleaning
15:26 Uhr
Seite 18
Publicidad
