Publicidad
Idiomas disponibles
Idiomas disponibles
10.2.1
Replacing the saw blade (Fig. 1)
▪
Set the saw to crosscut and mitre saw mode.
▪
Place the blade spanner on the outer flange and undo the saw blade screw (a) by turning
it in a clockwise direction using the Hex key S6. Remove the saw blade screw (a) and the
outer flange.
▪
Remove the saw blade (18) from the inner flange carefully. Lift the lower blade guard (14)
upwards by pressing switch A,
▪
Thoroughly clean the motor shaft and flange before you fit and secure the new saw blade.
▪
Fit and fasten the new saw blade in reverse order.
WARNING: The work to change and align the saw blade must be carried out
correctly.
10.2.2
Mounting upper blade guard (Fig. 2)
▪
Loose the two screws slightly by turning them in a counter-clockwise direction using the
Hex key S5.
▪
Hold the upper blade guard (3) with one hand and the other hand hold the left lower metal
board (b).
▪
Align the two sector gap on the metal board with two screws near the work-light, then
insert the metal board along the table liner slot.
▪
Control the space between the knife Head and the metal board between 3~8 mm.
▪
Tighten the two Screws by turning them in a clockwise direction using the Hex key S5
(26).
CAUTION: Controlling the space between the knife head and the metal
board can prevent the saw blade from cutting to the upper blade guard (3),
thus preventing accidents when operating the machine.
11 FUNCTIONS
11.1
Converting the saw from table to mitre saw for Cross-cut and mitre saw mode
(Fig.3)
▪
Tighten the turntable locking knob (9) and beveling lock (16) by turning them clockwise.
▪
Pull the table locking pin (38), push up the upper table (1). Pull the locking knob (22), then
lift the saw table so that it moves into the highest position.
▪
The saw has now been set to Cross-cut and mitre saw mode.
▪
Switch A (7) and the trigger switch (20) are used for starting/stopping the mitre saw.
11.2
Converting the saw from mitre to table saw operating mode (Fig. 4)
▪
Move the turntable to the 90° position, bevel angle at 90° position.
▪
Tighten the turntable locking knob (9) and the beveling lock (16).
▪
Hold the cutting handle (6) and press switch (7)
▪
Push down the cutting handle to the end and plug in the saw mode locking pin (22) at the
same time
▪
Pull the table locking pin (38), at the same time pull down the upper sawing table (1) to the
lowest position and release the locking pin (38) once the upper table is in the lowest
position.
▪
The saw has now been set to table saw mode.
▪
The ON/OFF switch (7) and the handle trigger (20) is used for starting/stopping the table
saw.
Copyright © 2023 VARO
POWX07583
P a g e
| 9
EN
www.varo.com
Publicidad
