Publicidad
Idiomas disponibles
Idiomas disponibles
▪
Undo the bevel lock (16) and use the cutting handle (6) to tilt the machine head to the left
until it coincides with the required angle value.
▪
Screw the bevel lock (16) back down again.
12.2
Table saw mode
12.2.1
ON/OFF switch (Fig. 17)
▪
The saw can be switched on by pressing the green pushbutton (I). Wait for the blade (18)
to reach its maximum speed before starting the cut.
▪
The red pushbutton (0) has to be pressed to switch off the saw.
12.2.2
Sawing (Fig. 18)
▪
Undo the table parallel fence lock knob (5).
▪
Set the table parallel fence (4) to the required dimension using the scale on the top saw
table and secure it with the locking knob (5).
▪
Switch on the saw by pressing the green button (I).
▪
Slide the work-piece slowly and precisely along the table parallel fence (4) to the saw
blade (18).
▪
The upper blade guard (3) will open automatically and the work-piece moves forward.
▪
Important: For work-piece widths below 120 mm a push stick (24) must be used in the
area near the saw blade (18). For work-piece widths below 30 mm a push stick (24) must
be used to move the work-piece.
▪
After completing the cut, the upper blade guard (3) will close again automatically to cover
the saw blade (18).
▪
Switch off the saw.
WARNING: The thickness of work-piece can't overstep 50mm in table saw
mode.
NOTE: Check that the "table parallel fence" is locked in position and is
parallel to the saw blade. Check that riving knife is properly aligned with the
saw blade.
NOTE: Secure long work-pieces against falling off at the end of the cut, add
an additional support to prevent the remaining part from falling down to
cause accidental risk.
13 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
13.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
▪
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Copyright © 2023 VARO
POWX07583
P a g e
| 13
EN
www.varo.com
Publicidad
