Publicidad
Idiomas disponibles
Idiomas disponibles
11.3
Adjustment of the turntable (Fig. 4-5)
▪
Turn the turntable locking knob (9) approx. 2 turns counter-clockwise, then adjust the
turntable (11) by pressing the angle adjustment control button (23).
▪
The turntable (11) has locking points at angles of 0°, 15°, 22.5°, 31.6° and 45°. Once the
turntable (11) is engaged, the setting must also be secured by turning the turntable locking
knob (9) clockwise.
▪
If different angle settings are required, the turntable (11) may be secured in position using
only the turntable locking knob (9).
11.4
Adjustment of the bevelling angle (Fig. 6)
The support arm can be tilted vertically and in an angle of 45° to the left.
To be able to tilt the support arm, the bevel lock (16) must be released.
To prevent the bevel angle from changing while sawing, the locking knob of
the support arm must be tightened.
11.5
Adjusting options table parallel fence (Fig. 7)
▪
The table parallel fence (4) is mounted on the top saw table. The table parallel fence
locking knobs (5) must both point towards the outside of the machine.
▪
The location of table parallel fence decides the cutting width. When the table parallel fence
is installed, you must always make sure that the fence is fastened with the locking knobs
(5).
▪
Once the locking knobs are released, the table parallel fence (4) can be removed.
11.6
Connection to a dust collector
The dust of some types of wood (such as for instance beech, oak and ash)
can be hazardous if inhaled. Always use a dust collector:
▪
If the saw is set up in an enclosed space;
▪
Whenever the saw is being used for longer periods of time (more than a half hour per
day);
▪
When sawing oak-, beech- or ashwood.
▪
The dust collector must conform to the following requirements:
▪
The diameter of the dust exhaust pipe must fit properly (31 mm);
▪
The air flow volume must exceed 550m³/h;
The vacuum at the dust exhaust exit must be ≥ 740 Pa;
▪
The air speed at the dust exhaust exit must be ≥ 20 m/s;
▪
▪
Follow the user instructions for the dust collector.
11.7
Assembly of dust bag (Fig.8)
▪
The dust bag (28) fits the mitre saw dust hole (27) and the table saw dust outlet (30).. To
ensure efficient operation, empty the dust bag when it is half-full.
▪
Never use the machine without the suction function. Regularly check and clean the suction
channels.
11.8
Laser line (Fig.9)
▪
Operate the ON/OFF switch for the laser light (34) during operation.
11.9
Work-light (Fig. 10)
▪
The combination saw is equipped with a work-light (31) under the top saw table, powered
by 3pcs AAA batteries.
▪
To switch the work-light on, press the ON/OFF switch for work-light (32) marked "I";
▪
To switch the work-light off, press the ON/OFF switch for work-light (32) marked "O"
Copyright © 2023 VARO
POWX07583
P a g e
| 10
EN
www.varo.com
Publicidad
