Publicidad
Mounting the Wind Speed Gauge Module
1. Remove the cover of the wind speed gauge module mount on the top of the dock cover. Remove the wind
speed gauge module from the box.
2. Use a 2mm hex key to remove the two screws on the wind speed gauge module base and make sure
to store them properly. Make sure that the DJI LOGO on the signal cable of the dock is facing correctly,
insert the signal cable gently to the port on the wind speed gauge module base, and properly and securely
tighten the screws.
3. Align and insert the wind speed gauge module into the mount on the dock cover. Use a 2mm hex key to
tighten the four screws and secure the wind speed gauge module.
Connecting and Powering on the Dock
4
Connecting the Earth Wire
• The dock must be properly grounded by following the
below requirements.
• Check that the design and assembly of the ground-
termination system meet the requirements before
installation. Make sure that the earth resistance
between the earth and the ground-termination system
connected to the dock is less than 10 Ω by using an
earth resistance meter for measurement.
• Gently pull the earth wire to avoid damaging the
terminal where the earth wire is connected to the
dock.
1. Gently pull the earth wire from the bottom of the dock. Make
sure to keep the earth wire as straight as possible, and avoid
coiling or intertwining with the signal cables.
2. Connect the earth wire to the lead-out pole of the earth
electrode, and tighten it with the M8 screw and nut.
Connecting the Ethernet Cable
• Make sure to install a data and signal surge protector device in the user computer room and
ensure that it is properly grounded. Refer to the Network Requirements section in the Installation
and Setup Manual for more information.
• Make sure to use a Cat 6 twisted pair cable with a cable diameter of 6-9 mm in order to guarantee
the seal is secure and that the water-resistant performance is not compromised.
• Make sure that the inner wire sequence is correct when connecting the pass through connector
and the cable by following the T568B wiring standard.
1
2
1
0.5 m
2
5
Publicidad
